Products
recommended product
Contact
Guangzhou Owleye
Optoelectronic
Technology Co.,Ltd.
Tel： 86-20-39218706
Fax： 86-20-39218705
Email： owleye@aliyun.com
Add： Block 1,Tian'an Hi-tech
Industrial Plaza 301,Panyu
Hi-tech Ecological Park,
No.555,Panyu North Avenue,
Panyu District,Guangzhou,
Guangdong,China.
LED embedded road stud
Your position: Home > Products > LED Road Stud
LED embedded road stud
LED Embedded road stud with four sides emit light
Item No.: LRSA3
Description:
4 sides emit light ;
Forging aluminum cover,High load-bearing, high impact resistance, friction resistance;
Connect with traffic signal light to make intelligent crossing road
- Content
- Specification
- Advantage
- Comparison
- Installation
- Application
- Purchase
Product introduction:
LED Road Stud operating by AC power mainly, some also by big solar panel power .
It is wired, constant light or controlled to be synchronous flash by controller
Size: D138*H66mm(Above ground: only 15mm)
Colour: Red/Yellow/White/Blue/Green
Light mode: Constant light or Synchronous flash
Input voltage: DC24V or DC 12V
Water-proof: IP68
Using temperature:-20℃～80℃
Load-bearing: >400kN
Visual distance: >800meters
Warranty: 1 year
Service life: >5 years
1. High load-bearing, high impact resistance, friction resistance ,corrosion resistance
2. 4sides emit light,making stronger visual impact feeling
3. Easy installation, replaceable inner part for easy maintenance, more 5 - year service life
| Item |
Other Supplier |
OWLEYE |
|
Material
|
Normal plastic,Recycled aluminum, low density ,bad performance,load bearing less than 15 tons
|
Bullet-proof PC, International standard GB-ADC10 Aluminum,high strong,good performance,load bearing more 40tons |
|
Inner part |
Unreplaceable |
Replaceable |
1.Before installation ,you must isolate the working place with road and make sure safety .
2.Determine the location of the installation, Then make a hole .
3.Ensure that the location of the installation level off, can not be installed on cracks and
uneven road surface.
●Open the necessary holes with Diameter:130mm , Depth : 50mm;
●Connect LED road stud and put the cable in the insulating protective tube then Pour the glue into the road stud hole and seal the protective tube ;
●Put the LED road stud into the hole;
●Ensure the right direction.If the glue is too much, it must be clean; Don’t cover the glue on road stud .
6. Checking within two hours after installation, ensure that all of the road stud no upside, loaded askew.7.Installation after 6 hours, you can removing isolation facilities.
Notes
●These details play a very important role in ensuring the quality requirements and service life of the LED
road stud ;
1. Quality assurance
Guangzhou Owleye Optoelectronic Technology Co.,Ltd. focus on the research,
production,development and application of road traffic safety produts. Specialize in
producing the high quality solar road stud and other road safety products for many years,please be free to purchase
2.Package
20pcs/ctn N.W： 15.2kg G.W：16.5kg Ctn size: 59*36.5*15.5cm
3.For shipping
Before knowing your destination and shipping way,all our quotation is EXW price,if you have
more requirements or want to know more about shipping ,please contact with sales
4. About after-sale service
Warranty is 1 year(non human reason). Just need to show the Contract or Proforma invoice
5. About service consultation
Tel: 020-39218706
Welcome your inquiry and nice long term cooperation,will make you satisfied
